Measure
- Daniel Leal (Unlicensed)
The Measure module is capable of measuring dimensions of objects based on the distance between two points, when the measuring lines that were drawed by the end-user, crosses the outline of an object, as described on video below.
For adding a line, simply place each point beyond the borders of an object you are going to measure and the line automatically detects the outline of the object.
Multiple lines can be added and the object has to be between the points of each line.
For optimal outline detection, set ‘Threshold’ value so the object borders are clearly visible.
Turn off the ‘Original image’ so you can see how the image looks after applying ‘Canny’
Measurement Unit & Precision
Mention how the unit works and what’s the expected precision.
maybe perform a test with a camera, with known values and extrapolate values for precision?
Explain
Measurement in pixels, if you would like to know the pixel to cm/mm conversion, this can be done my including a ruler in
Evaluation
When the end-user click on ‘Evaluation’ button, a threshold can be set for line length, alongside with comparisons rules, then click ‘Enable'. Lastly, click on Save and Close’.
Canny Settings
Canny settings can be modified by using the pointer or typing a desired value, this configuration is related to the canny edge detector. It should be adjusted when the the line is measuring other edges around the picture, causing meausing inconsistences.
Read more about at PreProcess article - Canny Edge Detector.
Original Image
When Original image is enabled, the original image is then displayed. When is disabled, the image is displayed with canny edge filter enabled (edges/outline of the image highlighted).
