...
The Unsupervised module available is /wiki/spaces/CONFLUENCE/pages/2982052 Anomaly of Surface, where the only required end-user input is to assign at least 1 image to as ‘OK’ class.
...
The Training mode for PEKAT are available for the following Modules:
/wiki/spaces/CONFLUENCE/pages/2982052 /wiki/spaces/CONFLUENCE/pages/7602237 /wiki/spaces/CONFLUENCE/pages/7602198 /wiki/spaces/CONFLUENCE/pages/7634958Anomaly of Surface Classifier DetectorSurface Detection
Below you can find a Training Overview Fluxogram, which demonstrates the overall training steps. However, for detailed training information a specific module each module, please access the desired module’s page.
...
The Training Model begins after clicking on ‘Start Training’ button, from that point a dialog window will display a training chart only for the following modules:
/wiki/spaces/CONFLUENCE/pages/7602237
/wiki/spaces/CONFLUENCE/pages/7602198
/wiki/spaces/CONFLUENCE/pages/7634958 Classifier
Surface Detection (Chart not available in Type 2 for option Experimental - The number of tranining cycles is defined by end-user)
...
Please note the chart is not available for the Module /wiki/spaces/CONFLUENCE/pages/2982052 Anomaly of Surface, as the Fast Training function for this module uses by default, the mininum value for number of training cycles. As for Deep Training function, the end-user defines the number of training cycles.
...
Extend model function is only available for the modules /wiki/spaces/CONFLUENCE/pages/7602237 & /wiki/spaces/CONFLUENCE/pages/7602198 Classifier& Detector.
This function allows you perform further training on an already trained model.
...
For detailed explaination regarding argumentation (training parameters), visit the following article /wiki/spaces/CONFLUENCE/pages/35422286 Augmentation Glossary.
Model Validation
By default, each training module is inactive and a model must be selected to activate (validate) it.
...